OTC 7073A Heavy-Duty Truck Clutch Alignment Tool – 10-Spline, 1-3/4″ OD, 1-1/4″ Pilot

OTC’s 10-Spline Truck Clutch Alignment Tool is designed for use when installing heavy-duty single, two-plate, push/pull, manual, and self-adjusting clutches. Tool is constructed of lightweight fiberglass-reinforced nylon that won’t hang up in clutch disc splines. Rugged construction will easily support the weight of heavy clutch discs. To use, loosely install clutch disc and pressure plate on flywheel then insert alignment tool through the clutch into the bearing, center disc, then tighten pressure plate to spec. Tool features: 1-3/4 inch O.D. shaft, 1-1/4 inch pilot, 10 splines, splines are 3.75 inches long. Value is at the core of the OTC tool and equipment portfolio. For a simple repair or the most complex drivability concern, these award-winning tools universally solve problems faster, and at better value, than any other product line available. Whether it’s a specialty tool or unique piece of service equipment, OTC provides top solutions to modern automotive service challenges while increasing technicians’ productivity and shop profits.

Make sure this fits by entering your model number.
OTC’s 10-Spline Truck Clutch Alignment Tool is designed for use when installing heavy-duty single, two-plate, push/pull, manual, and self-adjusting clutches
Tool is constructed of lightweight fiberglass-reinforced nylon that won’t hang up in clutch disc splines
Rugged construction will easily support the weight of heavy clutch discs
To use, loosely install clutch disc and pressure plate on flywheel then insert alignment tool through the clutch into the bearing, center disc, then tighten pressure plate to spec
1-3/4 inch O.D. shaft, 1-1/4 inch pilot, 10 splines, splines are 3.75 inches long; similar to Ford 308-D002 (D79T-7550-B)